Magnetic Couple Rodless Cylinder Cy1r6 10 15 20 25 32 40-100 150 200 300 Negs

BbpToLubrication-Free-Use Oil Bearing, Use Piston Rod without Oil Lubrication.

BbpTo Durability-the Cylinder Body Is Made of Stainless Steel, Which Is More Wear-Resistant and Durable.

○High Temperature Resistance-High Temperature Resistant Sealing Material Can Be Used to Make the Cylinder Work Normally at 150 Degrees High Temperature (Customers Need to Customize with Our Company.)

○ Various Installation Forms-a Variety of Installation Accessories Are Available.

※ Product Parameters ※

※ Product Big Picture ※

※ Product Application ※

CylinderIt Is an Important Executive Element, Which Converts the Pressure Energy of Compressed Air into Mechanical Energy, and the Driving Mechanism Performs Linear Reciprocating Motion, Swinging and Rotating Motion.

※ Usage ※

(1) Normal Working Conditions of Cylinder: Medium and Ambient Temperature Are Generally-20 ~ 80℃, and Working Pressure Is Generally 0.1~1.0MPA. The Specific Conditions Are Shown in the Technical Parameter Table of Various Cylinders.
(2) before Installation, the Test Should Be Conducted under 1.5 Times the Working Pressure, and No Air Leakage Should Be Allowed.
(3) Atomized Lubricator Should Be Set at the Inlet of the Installed Air Source to Facilitate Lubrication during Work. Reasonable Lubrication of the Cylinder Is Extremely Important. It Often Crawls Due to Poor Lubrication and Even Fails to Work Normally.
(4) When Installing, Pay Attention to the Action Direction, and the Piston Rod Is Not Allowed to Bear Eccentric Load Or Transverse Load.
(5) When the Load Changes in the Process, the Cylinder with Sufficient Output Force Should Be Used and the Buffer Device Should Be Attached.
(6) Do Not Use Full Stroke, Especially When the Piston Rod Is Extended, Do Not Make the Piston Pongee with the Cylinder Head. Otherwise, It Is Easy to Cause Damage to Parts Such as Piston and Cylinder Head.

Cylinder Force:

Determine the Thrust and Tension on the Piston Rod According to the Force Required for Work. Therefore, When Selecting the Cylinder, the Output Force of the Cylinder Should Be Slightly Margin. If the Cylinder Diameter Is Small and the Output Force Is Not Enough, the Cylinder Cannot Work Normally; However, the Cylinder Diameter Is Too Large, Which Not Only Makes the Equipment Heavy and Costly, but Also Increases the Gas Consumption, Resulting in Energy Waste. When Designing the Fixture, Force-Increasing Mechanism Should Be Adopted as Far as Possible to Reduce the Size of the Cylinder.

Formula for Calculating Theoretical Output of Cylinder:

Key Features

Connection Form: Thread
Brand: NGS
Magnetic: Yes
Guide: Built-in Guide Slot
Rotation Direction: No Rotation
Type: Non-Adjustable Buffer Cylinder
Manner of Execution: Impact Gas
Theoretical Force: 3.8-4000n
Maximum Load: 1N
Nozzle Thread: 9mm